A screen where you can check last year’s mining status has been prepared again this year.
Tapping !Bye2023 in the bottom right allows you to check last year’s mining count, the number of Pi mined, the number of referrals, etc. Last year’s mining count was 357 times. Although I perform the mining operation every day, there were situations where I forgot to press or couldn’t press when I had errands, resulting in me pressing several hours later. I think such instances accumulated and caused a discrepancy in the mining count. Assuming you can earn 10 Pi per day. If you missed 8 days, that would be an opportunity loss of 80 Pi. By the way, it was 351 times in 2022. If you’re interested, please check this screen.

Total Mining Count Disappears After Passing KYC

What I noticed when looking at this screen is that the display of the total mining count was gone from the Pi app. It seems the display disappears after passing (completing) KYC. When I asked how to display this using the chat function within the Pi app, I received a response stating that although the display disappears, it can be calculated by applying the following formula. (Thank you, 700t)

Formula

10^((((①Lockup Reward)÷100)÷(①Duration))÷(②Lockup Ratio))=Mining Count
By substituting the values of the lockup settings you initially committed to into the formula above and searching on Google, the calculation result (Total Mining Count) will be displayed. It seems the many parentheses are to prevent the Google calculator from malfunctioning.

The information needed for the formula is displayed by going to the three lines in the top left → Mainnet → Lockup Rate Settings.

① Lockup Reward
Expected Mining Boost
In the image, 594.61%

② Duration
2 Weeks → 0.1
6 Months → 0.5
1 Year → 1
3 Years → 2

③ Lockup Ratio
25% → 0.25
50% → 0.5
90% → 0.9
100% → 1.0

Applying my conditions resulted in the following:
10^((((594)÷100)÷(2))÷(1))=933

This means I have mined 933 times.

With this, you can calculate your total mining count.
I was planning to count down to 1000 total mining button presses, but since it doesn’t show up without calculation, I might accidentally pass it. Since it doesn’t appear on the screen, it will be a matter of self-satisfaction.